The kit comes pre-bent with stainless steel .375" tubing that can be cut to length to fit your application. This will do all the fuel lines needed in the engine bay that is not running a stock fuel pump application. You will need a soft line from the back of the tin union to the chassis fuel line outlet.
The kit comes with everything you see in the picture.
- Carb fittings
- B nuts
- Sleeves
- Tee
- Gauge adapter
- Liquid filled psi gauge
- Tin union with nut
- 2x mandrel bent carb lines
- 1x center line
- 1x drop down line
You will need a cutting device of some kind, we recommend a tubing cutter. You will need a 37 degree flaring tool as well. Check our
tool section if you don't already have them.
hard fuel lines 
