Classic VW Brazilian Bus PRObuilt Drop Spindles | Service | 2444B

What's included in the PRObuilt Spindle Service?

• The PRO's send a pre-paid shipping label (with insurance $1000) or have FedEx pick up the wrapped up, boxed or placed in a Home Depot Bucket set of Type 2 spindles
• Break down the spindles, clean, inspect and notify you of condition
• Media blast all components
• Clean up spindle nut threads
• Clearance carrier
• Weld gussets to carriers
• Reverse taper for the new flipped tie rod ends
• Install new Oil Impregnated Bronze Bushings as needed
• New King Pins from Wolfsburg West
• Press spindles back together w/ new seals
• Install NEW grease fittings and NEW kingpin retaining bolts
• Meyle adjustable tie rod assembly so tie rod ends can now come from the bottom
• The PRO's ship them back to you insured ($1000) with a signature needed for release

  ---

• Go with the powder coated versions for these spindles to have a finish that will last a lifetime
• It is recommended you check the adjustments in your link pins ever 2500 miles or every year. There is a square end on the back of the link pin that you can adjust to tighten up. It will require you to loosen the clamp bolts to do this.
• It is recommended to grease the upper and lower zerks every 2500 miles or every year to keep the system lubricated.
• When installing brakes on these spindles and it is time to adjust the bearing thrust, you need to tighten the bearings until the drum or rotor does not move by hand, then back off 1/4 turn and lock it down. This will ensure that as long as you packed your bearings correctly, lubed the seal correctly, this too will last forever* and failure will almost be non-existent.

  ---

Kewl Features

• Assembled by the PRO's in the USA.
• Bolt-On ready
  
• 3.5 inches of drop

  ---

FAQ

• Are you able to guarantee that the assembled spindles on your VW now are done correctly to keep YOU and YOUR family SAFE? If you are, perfect. If you can't, the PRO's at Airkewld will give you that confidence as long as you install them correctly.
• Why would I choose a raw steel finish over a powder coated finish or vice versa? Since most spindles on the market are delivered raw, you would need to finish them to match the look of your current drive-train, at least the OCD TEAM over here would. But, if you want to sign off on this part of your suspension lasting forever, then going the powder coated route makes sense.
• What if I want less of a drop that 3 1/2 inches? If you are looking to get a precise drop on your current Volkswagen, it's going to be difficult but attainable. Your VW should have original torsion springs inside the beam, these hold the vehicle up. But they have sagged or lost some amount of tension over the years. So trying to do that math and give you exactly what you want visually, will be difficult. Best decision would be to install new torsion leaves to raise the vehicle up, then understand how much you want to drop it. If 3 1/2" gives you the right drop, the PRObuilt Spindles Service is a perfect addition to your VW.
• I have slop in my king pins, does these PRObuilt Drop Spindles fix this problem? We replace the factory king pins and bushings with this service.
• I want to add disc brakes to my Type 2 Bus, will your Gen 1 or GEN 2 set of BAD Series Disc Brakes fit them? Yes. Our BAD Series Disc Brakes fit your factory bus spindles, regardless of being stock or dropped.