Parts List
The Ultimate Beam comes Satin Black Powder coated with adjusters installed, delrin bushings, grease zerks and hardware for shocks and adjusters. Torsions, Tie rods or tie rods ends do not come with the beam but are optional below in the accessories section. You can add them to your order by just checking the box next to the add word. The beam will normally be built in a 4 inch narrowed configuration as that is the most versatile. Should you need something stock width to 4 inch narrowed, you can mention in the additional comments section what you want.
Recommendations
Pick up the installation kit for trouble free installation and piece of mind that all boxes are check and you can put your stamp on it.
The installation kit comes with the body mount rubbers, upper and lower, stainless beam bolts, inspection plate cover with seal, 4 premium tie rod ends and a premium steering dampener.
Applications
The Ultimate Beams are built for all Beetles, Ghias and Things. Pre 66 vehicles have link pin models and 66-later models have ball joint. These beams are not interchangeable.
Why an Ultimate Beam?
Do you need to lift or lower your front end? Are your wheels scrubbing the fenders? Did you add some disc brakes or drop spindles on your ride and now they stick out? Are you trying to achieve a certain look? If any of these questions pertain to a need that you have, then The Ultimate Beam is your answer. The Ultimate Beam has about seven inches of adjust-ability so you can fine tune where you want your car. Because of the adjuster we use, you can adjust your car up and down by 1/16th inch increments. That means you can get the exact height and look you are after. If your wheels are sticking out after a disc brake addition, installing drop spindles or after installing a new set of wheels, The Ultimate Beam is the product to remedy this issue. We can narrow a beam up to 4? with shock towers and no body modifications. The inside dimension is 29 13/16". That gives a clearance of 1/16" on each side.
Pro's versus Con's
These beams are built with 100% brand new parts made in the USA. Each front end is jig built to ensure straightness and longevity. The beams are MIG welded for strength and clean looks. Everything is assembled for the best fit and finish. You can have an adjustable beam now and install air ride at a later time with out issue.